http://arxiv.org/abs/2212.07938
Building upon existing signal processing techniques and open-source software, this paper presents a baseline design for an RF System-on-Chip Frequency Division Multiplexed readout for a spatio-spectral focal plane instrument based on low temperature detectors. A trade-off analysis of different FPGA carrier boards is presented in an attempt to find an optimum next-generation solution for reading out larger arrays of Microwave Kinetic Inductance Detectors (MKIDs). The ZCU111 RF SoC FPGA board from Xilinx was selected, and it is shown how this integrated system promises to increase the number of pixels that can be read out (per board) which enables a reduction in the readout cost per pixel, the mass and volume, and power consumption, all of which are important in making MKID instruments more feasible for both ground-based and space-based astrophysics. The on-chip logic capacity is shown to form a primary constraint on the number of MKIDs which can be read, channelised, and processed with this new system. As such, novel signal processing techniques are analysed, including Digitally Down Converted (DDC)-corrected sub-maximally decimated sampling, in an effort to reduce logic requirements without compromising signal to noise ratio. It is also shown how combining the ZCU111 board with a secondary FPGA board will allow all 8 ADCs and 8 DACs to be utilised, providing enough bandwidth to read up to 8,000 MKIDs per board-set, an eight-fold improvement over the state-of-the-art, and important in pursuing 100,000 pixel arrays. Finally, the feasibility of extending the operational frequency range of MKIDs to the 5 – 10 GHz regime (or possibly beyond) is investigated, and some benefits and consequences of doing so are presented.
C. Bracken, E. Baldwin, G. Ulbricht, et. al.
Fri, 16 Dec 22
14/72
Comments: N/A