http://arxiv.org/abs/2006.15080
Reducing the impact of seismic activity on the motion of suspended optics is essential for the operation of ground-based gravitational wave detectors. During periods of increased seismic activity, low-frequency ground translation and tilt cause the Advanced LIGO observatories to lose
lock', reducing their duty cycles. This paper applies modern global-optimisation algorithms to aid in the design of thesensor correction’ filter, used in the control of the active platforms. It is shown that a particle swarm algorithm that minimises a cost-function approximating the differential RMS velocity between platforms can produce control filters that perform better across most frequencies in the control bandwidth than those currently installed. These tests were conducted using training data from the LIGO Hanford Observatory seismic instruments and simulations of the HAM-ISI (Horizontal Access Module Internal Seismic Isolation) platforms. These results show that new methods of producing control filters are ready for use at LIGO. The filters were implemented at LIGO’s Hanford Observatory, and use the resulting data to refine the cost function.
J. Carter, S. Cooper, E. Thrift, et. al.
Mon, 29 Jun 20
62/79
Comments: 19 Pages, 8 Figures
You must be logged in to post a comment.