http://arxiv.org/abs/1510.07088
The Extreme-ultraviolet Imaging Spectrometer (EIS) on the Hinode spacecraft observed flare footpoint regions coincident with a surge for a M3.7 flare observed on 25 September 2011 at N12 E33 in active region 11302. The flare was observed in spectral lines of O VI, Fe X, Fe XII, Fe XIV, Fe XV, Fe XVI, Fe XVII, Fe XXIII and Fe XXIV. The EIS observations were made coincident with hard X-ray bursts observed by the Reuven Ramaty High Energy Solar Spectroscopic Imager (RHESSI). Overlays of the RHESSI images on the EIS raster images at different wavelengths show a spatial coincidence of features in the RHESSI images with the EIS upflow and downflow regions, as well as loop-top or near-loop-top regions. A complex array of phenomena was observed including multiple evaporation regions and the surge, which was also observed by the Solar Dynamics Observatory (SDO)/Atmospheric Imaging Assembly (AIA) telescopes. The slit of the EIS spectrometer covered several flare footpoint regions from which evaporative upflows in Fe XXIII and Fe XXIV lines were observed with Doppler speeds greater than 500 km s$^{-1}$. For ions such as Fe XV both evaporative outflows (~200 km s$^{-1}$) and downflows (~30-50 km s$^{-1}$) were observed. Non-thermal motions from 120 to 300 km s$^{-1}$ were measured in flare lines. In the surge, Doppler speeds are found from about 0 to over 250 km s$^{-1}$ in lines from ions such as Fe XIV. The non-thermal motions could be due to multiple sources slightly Doppler-shifted from each other or turbulence in the evaporating plasma. We estimate the energetics of the hard X-ray burst and obtain a total flare energy in accelerated electrons of $\geq7\times10^{28}$ ergs. This is a lower limit because only an upper limit can be determined for the low energy cutoff to the electron spectrum. We find that detailed modeling of this event would require a multi-threaded model due to its complexity.
G. Doschek, H. Warren, B. Dennis, et. al.
Tue, 27 Oct 15
32/76
Comments: 42 pages, 18 figures
You must be logged in to post a comment.